Multishaft fastening sistem
It is a nutrunner system for multishaft fasteners composed of a multi-unit and axial unit tools.
It is the futuristic fastening system that responds simply to the complicated fastening needs.
A maximum of 31 high-speed multishaft connections can be controlled.Many sequential functions and flexible communication functions are installed in a small body.
The multi-unit input power source is made up of a wide range of input voltages (Single phase AC 100V ~ 220V) and environment-friendly low power consumption (15W) structure.
Contributes to a reduced-wiring system and flexible system.If necessary correspondence to various networks is achieved by integrating a minimum number of modules.
Basic System Functions
- Fastening methods
- Torque method, angle method; yield method and electric current method (CW/CCW fastening)
- Fastening accuracy
- Error rate within 2 % and within 3σ/ average 2%. Corresponds to ISO5393 A rank accuracy
- Monitoring
- Torque, angle, torque rate, time and electric current
- Fastening sequence
- 16 types (Maximum 100 steps for each)
- Fastening parameters
- 16 groups (Maximum 50 data for each)
- Fastening result data display
- Free selection from maximum 29 types
- Fastening range
- 1 NM ~ 5,000 NM
- Maximum number of shaft that can be connected
- 31 shafts (More than 31 shafts can be connected by interlocking between multishafts)
Set and monitor function
- OS
- User console Windows 95, 98, Me, NT, 2000, XP
- Set functions
- Required basic settings and fastening setting value etc. are set for system
Sequence, parameters, communication, I/O and other
- Monitoring functions
- Monitoring of nutrunner state, fastening result, etc.
Fastening result, I/O status and fastening waveform and others
- Help function
- Supports operation methods etc.
Display system
＝Set indicators (Touch screens)=
Connected to the multi-unit and used in result display of nutrunner, setting value confirmation and simple operations etc.
Control panel, operator control panel (power head) and portable use etc. can be selected.
Cost merits can be assured for commercial-type general purpose products.
| Display |
・ Fastening result display
・ Fastening details display
・ Fastening OK shaft location display
・ Fastening waveform display
・ Set value display |
| Operations |
・ Nutrunner basic operations (startup, reset, reversal）
・ Calibration confirmation function |
|
|
 |
Panel computer （ＨＭＩ）
It is a stationary PC embedded in control panels etc..
Corresponds to touch screens and user console function for the nutrunner setting and management can be used 100%.
 |
|
●When data is to be saved at any one given point in time.
(It can be freely saved in the recording medium supported
by the PC such as HDD, FDD, MO and FLASH etc.) ) |
| ●Reports to high order host which uses E-NET |
| ●Large amount of wave-form and data analysis |
●Operation assistance by on-demand help function
Maintenance assistance etc. during errors |
|
